LightIt! 20020-108 Installation Guide download pdf

Please Read This Before You Start

The 8-LED Sensor Lamp uses both a MOTION sensor and a

PHOTO sensor. The photo sensor prevents the light from being activated

during daylight hours or when other light sources are present. When

batteries are installed the light will come on and the electronic circuitry will

set. The light will turn off when the process has completed. If the light does

not turn off after battery installation and initial circuitry set, we recommend

testing the unit by placing it in dark room away fromany possible heat and

light sources. If operating normally, the light should turn off after 30-45

seconds if no motion is present. Light should turn back on when motion is

again detected. If light does not function properly please see Troubleshoot-

ing below or contact us for further assistance.

Automatic Operation & Detection

In the Sensor mode lamp operation is completely automatic. The lamp has a

60 degree detection “cone” with a maximum detection range of 12’. This

limited detection range is intended to provide more user control and to

avoid unintentional activation. Please note that the sensor requires a clear

“line of sight” to operate correctly and that the lamp sensor must be

pointed toward the desired detection point. To ne tune detection, simply

turn the lamp (and sensor) slightly toward the preferred detection zone.

Troubleshooting

Light will not turn off

Test the light as instructed above.

Light will not turn on

Check to make certain that your batteries are fresh.

Check the alignment (polarity) of the batteries.

Check to make certain that the battery holder has been properly installed

and the contacts properly aligned.

Detection does not occur or is too frequent

Please review information on operation and detection.

Check to make certain that there are no obstacles blocking the sensor’s “sight”.

Experiment with different locations to nd the one that best suits your needs.

Check to make certain that the sensor is correctly aligned, adjusting it as

indicated above.

Fulcrum Products, Inc. • info@fulcrumproducts.com • 503-274-1227

Troubleshooting 1

Summary of Contents

Page 1 - Troubleshooting

Please Read This Before You Start The 8-LED Sensor Lamp uses both a MOTION sensor and aPHOTO sensor. The photo sensor prevents the light from being ac

Comments to this Manuals

No comments

LightIt! 20020-108 Installation Guide

Browse online or download Installation Guide for Unknown LightIt! 20020-108. LightIt! 20020-108 Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown LightIt! 20020-108